Lectron Tuning

 

NOTE: THE INITIAL METERING ROD SETTING SHOULD BE 45mm (1.772") FROM SLIDE INSERT TO END OF METERING ROD.

When working with dual carburetors it is necessary to measure the length of each metering rod to make sure both rods are at the same position.  If the rods are not equal, one cylinder will run leaner than the other.

NOTE:  The metering rod that is supplied with your Lectron Carburetor is recommended for a standard, serial production version of your motorcycle in a normal state of tune.  Any variations of tuning beyond the way your motorcycle was manufactured and subsequently maintained will affect the recommended metering rod and setting.

Turn metering rod in direction of Arrows "A" (richer), "B" (leaner) for idle mixture adjustment as shown in "Figure 2".  Push in on rod as shown by Arrow "C" and rotate rod until Flat is in position as shown and release.

Note:  Make sure holder is in notches in slide and there is equal amounts of free play in both directions "A" and "B".